Issue in Predictor V2022.1 and V2022.11
The issue occurs when creating a new LimA-CNOSSOS model in Predictor V2022.1 or V2022.11.
- The default ground factor of 0.0 in the calculation settings when creating a new model was internally calculated as 10.0.
- The default meteo location in the calculation settings of a new model was shown as ‘default’ but was internally calculated as homogeneous.
When these defaults setting were left unchanged this resulted in very low results.
To correct this issue in V2022.1 and V2022.11 you are advised to do as follows:
- Open the Calculation settings.
- Change the ground factor to 1.0 and select ‘favorable’ in the drop down list of the meteo locations.
- Click on the OK button.
- Open de Calculation settings.
- Change the ground factor to 0.0 and select ‘default’ in the drop down list of the meteo locations.
- Click on the OK button.
This issue does not occur with models that were originally created with Predictor V2022.0 or earlier. Also when these projects were updated to V2022.1 or V2022.11 the issue does not occur.